DESIGN, IMPLIMENTATION AND FABRICATION OF PERMANENT MAGNET SYNCHRONOUS GENERATOR.
- Electrical Engineering Department,Gandhinagar Institute of Technology, Gandhinagar.
- Abstract
- Keywords
- References
- Cite This Article as
- Corresponding Author
This paper presents a study on material selection basis on characteristics, model designing calculation and designed model analysis using 2-dimensional (2D) analysis of magnetostatic analysis and its fabrication process for the permanent magnets machine. Conventional machines are having higher reactance losses in windings and difficult manufacturing process because of its design. Proposed design of machine is fully based on conventional stator and rotor geometry consisting permanent magnets and special type of winding to lower the reactance losses. Machine is fully fabricated locally and tested.
- IJSR article on chemistry, properties and uses of Nylon material by parth vagholkar, September 2016, volume 5.
- IEEE paper on Design, Fabrication and analytical investigation of permanent magnet generator by Subhrakanti Nanda and Mainak Sengupta, 978-1-4799-6373-7/14.
- Paitandi And M. Sengupta, Design, analysis of a PMSM and its comparative study With an Induction Machine of same nominal rating, NPEC, December 2013, IIT Kanpur.
- IEEE paper on Sizing and optimization models: design of a set of two Permanent magnet generators by Carlson, F. Wurtz, H. Voltolini978-1-4673-0141-1/12.
- Bachelor?s thesis on Design of a permanent magnet generator with compensated reactance winding by Oleg Lyan and Vincent Monet,
- Klaipeda, 2013.
- Master thesis on ?Design and Construction of a Permanent Magnet Synchronous Motor? by Miss Sisuda Chaithongsuk, king mongkut?s institute of north Bangkok, 2006.
- IEEE paper on the design of pmsm rotor with ferrite magnets to substitute rare earth permanent magnets system by Aryanti Kusuma Putri, Martin Nell, Marco Hombitzer, David Franck and Kay Hameyer, 978-1-5386-2477-7/18.
- Design and control of a PMSM drive for hybrid electrical vehicle by Carlson, F. Wurtz, H. Voltolini.
- IEEE paper on Permanent magnet synchronous motor magnet design with skewing for torque ripple and cogging torque reduction by R. Islam, I. Husain, A. Fardoun and K. Mclaughlin, 0197-2618/07.
- Journal of electrical engineering paper on effects of rotor skew angle on flux switching permanent magnet (FPSM) machine characteristic by Mostafa, Seyyed Mehdi and Fabrizio.
[Yash R. Khakhi. (2019); DESIGN, IMPLIMENTATION AND FABRICATION OF PERMANENT MAGNET SYNCHRONOUS GENERATOR. Int. J. of Adv. Res. 7 (May). 224-232] (ISSN 2320-5407). www.journalijar.com