Vol. 8 (06) pp. 1542-1549 DOI: 10.21474/IJAR01/11245

THE INFLUENCE OF MICROALLOYING ELEMENTS ON CUTTING FORCE AND ROUGHNESS OF AUSTENITE STAINLESS STEEL

, and
  • Institute Kemal Kapetanovic, University of Zenica.
  • Faculty of Metallurgy and Technology, University of Zenica.
16 Downloads 67 Views
Crossref

Download Full Paper (PDF)

Abstract

More recently a modified stainless steels have been used to produce various structural elements that work in complex operating conditions. Stainless steel X8CrNiS18-9 is the most commonly used austenitic stainless steel due to its good machinability. This steel has high mechanical and working properties thanks to a complex alloying, primarily with the elements such as chromium and nickel. The content of sulphur present in the steel from 0.15 to 0.35% improves machinability. The aim of this work is to determine the influence of microalloying with boron, zirconium and tellurium on the cutting force and roughness the mentioned steel.

Keywords

Article Analytics

How to Cite This Article

Sc. Dervis Mujagic, Sc. Aida Imamovic and Sc. Mustafa Hadzalic (2020); THE INFLUENCE OF MICROALLOYING ELEMENTS ON CUTTING FORCE AND ROUGHNESS OF AUSTENITE STAINLESS STEEL, Int. J. of Adv. Res., 8 (06), 1542-1549, ISSN 2320-5407. DOI: https://doi.org/10.21474/IJAR01/11245

Corresponding Author

Dervis Mujagic
Institute Kemal Kapetanovic, University of Zenica
Creative Commons Attribution 4.0 This work is licensed under a Creative Commons Attribution 4.0 International License.