MODELING AND SIMULATION OF ENGINE CYLINDER FINS BY USING FEA

R. ARULARASAN; P. HEMANANDHAN; T. THAMIZHSELVAN; B. ARUNKUMAR; S. SENTHILNATHAN; S. PRATHAP

31 Jan 2016 Vol. 4 (01) pp. 1391-1396

MODELING AND SIMULATION OF ENGINE CYLINDER FINS BY USING FEA

R. ARULARASAN, P. HEMANANDHAN, T. THAMIZHSELVAN, B. ARUNKUMAR, S. SENTHILNATHAN, S. PRATHAP

Faculty, Department of Mechanical Engineering, University College of Engineering Arni Thatchur, Thiruvannamalai(DT)-632326,India.
UG Student, Department of Mechanical Engineering, University College of Engineering Arni Thatchur, Thiruvannamalai(DT)-632326,India.

84 Downloads 215 Views

Download Full Paper (PDF)

Abstract

In this design the single cylinder air cooled engine to be analysis with different profile fins such as triangular, rectangular, elliptical, trapezoidal profile and compare the existing profile of the engine.Comparative thermal tests will be carried out using Aluminum two stroke S.I engine made with triangular fin,with rectangular, elliptical, trapezoidal profile without varying material properties of engine block. A cylinder with a single fin mounted on it to be tested. The numerical simulation of the same setup was done using ansys. The main of aim of this work is to study various researches done in past to improve heat transfer rate of cooling fins by changing cylinder block fin profiles.

Keywords

How to Cite This Article

R. ARULARASAN, P. HEMANANDHAN, T. THAMIZHSELVAN, B. ARUNKUMAR, S. SENTHILNATHAN, S. PRATHAP (2016); MODELING AND SIMULATION OF ENGINE CYLINDER FINS BY USING FEA, International Journal of Advanced Research (IJAR), 4 (01), 1391-1396, ISSN 2320-5407.